Datamax-oneil DMXNetII Manuale Utente

Operation & Installation92-2495-01 Rev.C

Printer’s Internal Web Pages 8 TCP/IP Configuration Page Static IP Settings IP Address Subnet Mask Default Gateway These are the static address t

Printer’s Internal Web Pages 9 Wifi Configuration Page WLAN Network Settings SSID Service Set Identifier that identifies the Module to connect t

Printer’s Internal Web Pages 10 Wifi Configuration Page (continued…) Advanced Settings Maximum Transmission Rate Specifies the Module’s maximum wi

Installing the Printer Driver 11 Installing the Printer Driver The following screen shots are taken from Windows® 2000, other Windows® versions wi

Installing the Printer Driver 12 9 Insert the Accessories CD-Rom and click ‘Browse’. 10 Browse to the “\DRIVERS\Seagull” folder on the CD-ROM, m

Additional Information 13 Wireless and Wired Ethernet Specifications The following list and table describes the key features and specifications of

Overview 1 Overview This document describes the installation and use of the DMXrfNetII and DMXNetII Card options for the H-Class, I-Class, and A-

Overview 2 Card Installation The following illustrations depict installation into an I-Class printer, other model installations are similar. 1.

Overview 3 Introduction These network cards can be equipped in the following configurations:  Wired and Wireless Ethernet  Wired Ethernet 

Network Setup 4 Network Card Reset It is recommended that the printer’s communication settings be reset to factory defaults to avoid any conflicts

Network Setup 5 Network Card Setup - Wireless (Infrastructure Mode) After a successful setup is made via a wired connection, the Wireless conn

Network Setup 6 Network Card Setup - Wireless (Adhoc Mode) To configure the wireless card in Adhoc mode, you must configure your host computer

Printer’s Internal Web Pages 7 Printer’s Internal Web Pages 1. Open your web browser. Type in the IP Address of the printer. The Default IP is: