Datamax-oneil H-Class GPIO Option Manuale Utente Scaricare il pdf (Pagina 12)

D) Place the Cover Plate (Item 2) onto

the Card Cage, as shown, then

install and tighten the two Screws

(Item 3) to secure the plate.

Cover Plate

Screws

Card Cage

Step 3: Interfacing

Interface the card according to your application requirements (see the drawing below for

connector pin-outs, refer to Step 1 for signal details) as follows:

A) For GPIO functions connect a GPI/O interface cable to the GPI/O A (J1) and / or GPI/O

B (J2) ports.

B) For RS232 communications connect a serial interface cable to COM C (J4) and / or COM

D (J3); for dedicated devices, connect the cabling from that device to COM C (J4).



Note: If using both the RFID and Linear Scanner, see Configuring Hardware

Settings, above.

C) Connect the AC power cord to the printer and then turn the power switch ON.

1 2 ... 7 8 9 10 11 12 13 14

Nessun commento

Datamax-oneil H-Class GPIO Option Manuale Utente Pagina 12