Datamax-oneil M-Class Mark II RFID Ready Option Manuale Utente

RFID Ready Option 92-2499-01 Rev.C

8 UHF Option: G) Secure the UHF Module (Item 10) to the Mounting Plate using the four Standoffs (Item 11) and four Screws (Item 8). StandoffsScrewsU

9 Step 3: Returning Operation A) Dress the installed cables into the existing cable bundle. RECHECK ALL CONNECTIONS. Lower and latch the Printhead

10 D) Enable the option by following the instructions below: EXITSYSTEMENTERPRINT CONTROLTESTMENUREADYSTOPERRORPRINTER OPTIONSUSER MENUSYSTEM SETT

1 Overview This document describes the contents and installation of the M-Class Mark II RFID options. Only qualified service personnel should per

2 Contents The contents of the kit differ according to the type of RFID option:  HF Option*: 1 Antenna 2 Regulator CCA 3 Mounting Plate 4

3 Tools Required A Phillips screwdriver is needed, and a PC with an Internet connection may also be required. Step 1: Checking Firmware A) Ver

4 B) Remove the Cover Screws on the outside of the printer. Cover Screws C) Raise the Cover. Loosen the Cover Screws on the Centerplate then

5 Step 3: Installing the Option A) Peel the backing from the Double-Sided Tape (Item 7). Affix the Double-Sided Tape to the recessed area of the A

6 D) Route the Antenna Cable through the Cableway in the Centerplate. CenterplateCablewayAntenna Cable E) Loosen the Guide Screw and the Heat S

7 HF Option: G) Place the Washer (Item 11) and then the Long Spacer (Item 10) onto the Screw (Item 8). Place a Short Spacer (Item 9) over the Long S