Datamax-oneil Class Series II Programmer’s Manual Manuale Utente Scaricare il pdf (Pagina 55)

Extended System-Level Command Functions

Class Series 2 Programmer’s Manual 41

STX KaW Write Data to RFID Tag

(Direct Mode – Generic Read/Write Interface)

This command instructs the RFID device to write data to the tag. It is expected that the

tag transponder will be within the read / write distance of the RFID programming device;

otherwise, a warning will occur and a warning message (Read / Write Fail) will be

displayed.

Syntax:

STX>KaWAaaabbbcdee…

Where:

Aaaa

Optional – for data in the ASCII format, followed by

the byte count (000-999).

bbb

HF – Starting block number (000  maximum block

number, which is dependent upon the

transponder manufacturer).

UHF – Should be 000.

Command 1. Reserved for Future (should be 0)

Command 2. Reserved for Future (should be 0)

ee…e

Data to be encoded on RFID tag (HF – the last used

block will be null-padded, if necessary).



UHF ASCII formats must be 8 or 12 characters; and,

UHF Hexadecimal formats must be 16 or 24

character pairs.

Sample:

<STX>KaW0000054455354[CR]

The sample above writes the data “TEST” at block zero.

STX Kb Backfeed Time Delay

This command controls the time a printed label is allowed to remain “presented” before

being retracted to the start of print position.

Syntax:

STX>Kbnnn

Where:

nnn

Seconds/10

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 333 334

Nessun commento

Datamax-oneil Class Series II Programmer’s Manual Manuale Utente Pagina 55